Service plans

Three plans. Pick the one that matches how hard your gate works.

Every plan includes the full checklist, a photo report per gate, and priority over non-contract calls. The difference is how often we show up. Choose a plan here, then pick your week and pay on the next page.

Semi-annual · 2 visits / yr

Steady

Quiet sites: HOA entrances, low-cycle swing gates, the back lot nobody uses after 5.

$375 first operator
per visit

+ $205 each additional operator, per visit

Two-operator site: $580 per visit, $1,160 a year across 2 visits.

  • Full inspection checklist and safety test
  • Photo report per gate, same day
  • Lubrication and minor adjustments included
  • Priority over non-contract service calls
Start with Steady

Monthly · 12 visits / yr

Heavy Duty

Distribution centers, parking facilities, and any gate that cycles more times a day than you'd like to count.

$375 first operator
per visit

+ $205 each additional operator, per visit

Two-operator site: $580 per visit, $6,960 a year across 12 visits.

  • Everything in Quarterly, every month
  • Same-week response, emergency line included
  • Wear parts stocked for your operators
  • Site-wide cycle log and annual condition summary
Start with Heavy Duty

Not ready for a plan? Pay per visit.

One maintenance visit, same checklist, same photo report, no contract. $375 for the first operator, + $205 each additional one. Pick your week and half of the day, pay for that visit, done.

Book a single visit

Plans are for operators that are currently working. If one is down, start with a repair visit and we will fold it into a plan once it is running again. Every plan is the same rate per visit; you are choosing how often we come. Sites more than 40 miles from Plymouth Meeting carry a travel adder. Need us after 5 PM or on a weekend? Flat $250 add-on per visit, no hourly premium. Pay for the year, per visit, or for a single visit by card through Clover.

What we check

Every visit ends with a report your property manager will frame.

The same checklist on every operator, every time, with photos. It is the difference between "we looked at it" and knowing exactly what is wearing and when it will need attention.

Gate Service Report Gate 3 · Cantilever slide · Visit 2 of 4
OperatorSlide, chain drive, 1 HP
Cycle count184,212 (+9,880 since last visit)
ResultPassed · 2 items to watch
  • Drive chain / belt tension and wearAdjusted 1/2 in. of slack, lubricated
  • Entrapment protection test (UL 325)Inherent reverse and edge sensor verified
  • Photo eyes and edge sensorsAligned, lenses cleaned
  • Loop detectors (exit, safety, shadow)Frequency and sensitivity checked
  • Battery backup load testHolding 12.6 V, replace at next visit
  • Wheels, track, rollers, and guide postsTruck wheels 40% worn, on watch
  • Limits, open and close timingClose limit re-set 1 in.
  • Control board, wiring, surge, and groundingTerminals tightened, enclosure sealed
  • Access devices: keypad, card reader, remotesAll codes verified with site contact
  • Gate hardware, hinges, alignment, and weldsNo cracks, hardware tight
14 photos attached · PDF emailed to site contact and property manager the same day

Ready?

Pick a week, pay once, forget the gate exists.